Clear Epoxy Resin, Magic Resin, 1 Gallon 3.8 L, Premium Quality Clear Epoxy Resin Kit, Non Toxic, High Gloss Thick Clear Coat
Premium quality - the product cures to a clear, high build, glass like finish that resists scratching, yellowing and will not distort with age. Non-toxic - enjoy this safe odor free and non-toxic resin epoxy for any kind of job. Easy to use - magic resin kit is a 100% solids, two component, clear polymer coating that is mixed at a 1 to 1 ratio by volume. Highly resistant - this product is scratch resistant, water resistant and will not exhibit blushing or sweat out under high humidity conditions. Coverage - 48 sqft seal coat (1 mm thick) or 16 sqft flood coat (3 mm thick). Clear epoxy coating for table tops, bar tops, counter tops and. Our product is used extensively by many.
Artists, contractors, commercial restaurant chains throughout the. World and also by many do-it-yourselfers.
Magic resin kit is a 100% solids, clear polymer coating that is. Mixed at a 1 to 1 ratio by volume. The product cures to a clear, . High build, glass like finish that resists scratching, yellowing. And will not distort with age.
Items coated with it will become. Permanently preserved and protected for your enjoyment throughout. This product will not exhibit blushing or sweat out.
The product should be applied in two stages. Referred to as the seal coat. The seal coat is brushed on in a.
Thin layer and is used to seal any pores in the surface and. Prevent air bubbles from forming in the following flood coats. This stage is followed by the flood coat, which will flow and. Self level, clean brushes or squeegee can be used to help spread.Flood coats are applied in 1/8 layers at a time, as. Many as desired can be applied, however one to three coats is.
Average for most table or bar coatings. Re-coating can usually be be done within 4 to 8 hours.
Re-coated within this time period no sanding is necessary between. If your previous layer has fully dried, very light.
Sanding with 220 grit sandpaper is recommended to achieve a good. After sanding you should wipe down with a. Solvent such as denatured alcohol or acetone to remove any.
(do not use mineral spirits).