It also is perfect for beginners wanting to attempt a river table. When used as a coating it self levels to about 1/8 with a rich clear gloss. Additional layers can be added after 24 hours at a minimum of 75f. For river tables it can be poured between 1/4" and 3/8" thick depending on volume and temperature.For the best results, expect a 30-min working time at 75f. After 24 hours from pouring and spreading, your epoxy table top finish is sandable at 75f. Once measured in the proper 1:1 ratio, stir until well combined. It should be crystal clear and free of striations before pouring. We don't recommend using a paddle mixer with this epoxy as it will be near impossible to remove all the bubbles before it starts to set up. Make sure the sides and bottom are continually scrapped to avoid unmixed resin ruining your project.